INSTALLATION
PROCESS
We recommend installation by a qualified installer if possible. If one
is not available follow the instructions below.
1. Calculate length of port needed:
Port Length
Calculator
2. Determine proper speaker & port placement before cutting any holes.
The Precision Port™ can be placed as close as 1” from the inside wall of
the enclosure although it is recommended to keep it as far away from the
inside wall as possible.
3. Once placement has been determined cut the proper size hole.
4. If you want to use screws to attach the port to the enclosure use the
guide marks on the back of the outside flare. The screw holes are
numbered with a 6 or 8 for the number of screws you would like to use.
DO NOT ATTACH INSIDE FLARE
UNTIL PORT HAS BEEN INSTALLED IN ENCLOSURE.
5. When the length has been achieved the Precision Port™ can be glued
together using ordinary ABS adhesive or similar type glue. Once pieces
are assembled with ABS adhesive, pieces can not be taken apart.
Assemble the Precision Port™ in the following manner.
1. Attach connecting rings to flared ends.
2. Slide flared ends, with connecting rings attached, over tube section.
DO NOT ATTACH INSIDE FLARE
UNTIL PORT HAS BEEN INSTALLED IN ENCLOSURE.
8. Insert the Precision Port™ into enclosure and secure with adhesive
and/or screws. It is recommended to use adhesive when screwing in port.
WARRANTY
The Precision port™ is warranted, to the original purchaser, for a
period of 90 days from the date of purchase. This warranty is limited to
any manufacturing defects. If such a defect is found contact the place
from which you purchased this product.
# 5,623,132
|
